Built for the houses that are actually here
South Whittier is an unincorporated part of Los Angeles County, tucked between Santa Fe Springs, La Mirada, Norwalk and Whittier proper. It filled in fast after World War II. The median home dates to about 1954 and runs around 1,300 square feet. Some tracts were designed by notable architects, like the Lake Marie Ranchos area near Painter Avenue and Mulberry Drive and the Hugheston Meadows homes close to Candlewood Country Club. Most streets are lined with practical single-story houses that have low roofs, simple gables and decades of add-ons.
That history shapes a metal roof job here. Original 1950s decks are often spaced board sheathing, sometimes with two old layers of shingles on top. Over the years, owners added patio covers, enclosed porches and back bedrooms, often with lower pitches than the main house. Each of those junctions is a leak waiting to happen, and each one needs proper metal flashing.
Metal options that fit a South Whittier home
Stone-coated steel is a favorite for owners who want a traditional shake, shingle or tile look without the weight. Concrete tile can be too heavy for an original 1950s rafter system. Stone-coated steel weighs a fraction of that, so the framing usually needs no added support.
Standing seam gives a clean, mid-century modern look that suits the simple lines of many tract homes, especially the post-and-beam style houses in the architect-designed neighborhoods. It is also the best surface for solar.
Low-slope metal is a great answer for those flat or nearly flat patio covers and back additions. A mechanically seamed panel handles a lower pitch than shingles ever could, so the slow-draining corner that leaks every winter stops leaking.
Heat, smog and Santa Ana winds
South Whittier is far enough inland to get properly hot, with summer days in the 90s and some heat waves above 100. The marine layer that cools the beach cities often burns off here by late morning. A reflective metal roof keeps more of that heat out of a small attic, which is a real help in homes where the air conditioner already works hard.
In fall and winter, Santa Ana winds can come through hard, lifting shingle tabs and tossing palm fronds and eucalyptus limbs onto roofs. Interlocking metal panels and stone-coated steel systems are rated for high winds, and they will not crack the way old tile does when a branch lands on them.
Permits and cool roof rules
Because South Whittier is unincorporated, reroof permits go through Los Angeles County Building and Safety rather than a city hall. We pull the permit and schedule inspections. California's Title 24 energy code also sets cool-roof standards for many reroofs, and we pick finishes with the reflectance and emittance ratings needed to comply.
What happens on install day
- We protect landscaping, the driveway and any cars, then strip the old layers down to the deck.
- We fix the deck. On board-sheathed homes, we often add new plywood over the boards for a solid, flat base.
- A synthetic underlayment goes down, with extra membrane at valleys, walls and low-slope sections.
- Panels go on, then ridge caps, rake trim and flashing at every wall, pipe, vent and chimney.
- We clean up, sweep the yard for metal and screws, and walk the job with you.
Cost, life span and making a choice
A metal roof costs more than shingles to install. It also lasts much longer, often two to three times longer, and it does not need the cycle of patching that older roofs in the neighborhood go through. On a 1,300-square-foot house, the gap is smaller than many people expect. We will price metal and asphalt shingle roofing side by side so you can compare.
Not sure the roof needs replacing yet? A roof inspection will tell you, and our flat roof repair service covers that patio cover in the meantime.
Want a price on a metal roof?
Call (562) 378-6831 and we will come out, measure, check the deck and the add-ons, and write up a clear quote.